PROFESSIONAL Series
WC10

1. IGBT module inverter technology.
2. Low cost cutting with high stable and stiff arc, which brings you smooth cutting notch and small cutting angle (ISO9013:2002(E) standard 4-5); less slag and warping; smaller heat affected area.
3. Pilot Arc Start increases cutting efficiency.
4. Conveniently and quickly cut metal plate.
5. Built-in air filter and regulator.
6. Equipped with over/under voltage, as well as insufficient compressor air pressure protection.
7. Smooth cutting surface with high cutting speed.
8. Widely used in cutting carbon steel, stainless steel, copper, cast iron and aluminium, etc.
9. Strengthened and protection on cutting torch connector largely enhances operator’s safety.
10. International Standard IEC 60974-1

Products Type	CUT 100
Model	WC10
Input supply	415V±10%, 3ph, 50Hz
Rated input current (A)	21.4
Rated input power capacity (KVA)	15.2
Power factor	0.9
Output current (A)	20-100
No-load voltage (V)	320
Rated duty cycle (%)	100
Arc starting	HF
Quality cutting thickness (mm)	25
Max cutting thickness (mm)	45
Recommended compressor capacity (L/min)	170
Recommended cutting pressure (Kg/cm)	4-6
Output characteristics	CC
Efficiency (%)	85
Protection class	IP-23
Insulation class	H
Dimensions (mm)	676 × 333 × 712
Weight (Kg)	56